10-23-2023, 05:18 PM
(This post was last modified: 10-23-2023, 08:40 PM by acrosstech.)
Hi folks,
I am stuck.
I have replaced the pcb and changed the firmware over.
The first time I ran it in DDL it started and the HDD ID
and specs were found. I then had to got to the recovery
for a disk image to place into the RAID but the drive is no
longer recognised no ID or anything.
I have reset it a number of times and still no details.
If I put a biz card between the pcb and the disk I get all
details but cannot spin up the disk after. Removing the
bizcard results in no HDD ID and details again.
Am I doing this badly? Can anyone suggest how to get
it to get the HDD ID and specs to finish the recovery please?
TIA
kind regards
Anthony
I am stuck.
I have replaced the pcb and changed the firmware over.
The first time I ran it in DDL it started and the HDD ID
and specs were found. I then had to got to the recovery
for a disk image to place into the RAID but the drive is no
longer recognised no ID or anything.
I have reset it a number of times and still no details.
If I put a biz card between the pcb and the disk I get all
details but cannot spin up the disk after. Removing the
bizcard results in no HDD ID and details again.
Am I doing this badly? Can anyone suggest how to get
it to get the HDD ID and specs to finish the recovery please?
TIA
kind regards
Anthony