01-15-2015, 08:31 PM
Hello to all Dolphin users,
the DFL-FRP for WD V2.63 is now available.
Within each upgrade, Dolphin Data lab will optimize the software codes, interface data and hardware combination codes to make sure the new firmware repair software works perfectly on the hardware.
Within the latest version of version of WD 2.63, Dolphin engineers have created the following changes and added new firmware repair features below:
1, PCB number display is added;
2, New families are added;
3, To Run ARCO 44 is added when the hard drives are not detected (Not all drives support this), sometimes when users try to write firmware but write failure, users can try to run ARCO 44 and then write again;
Read full details here: http://www.dolphindatalab.com/2015-new-d...l-upgrade/
the DFL-FRP for WD V2.63 is now available.
Within each upgrade, Dolphin Data lab will optimize the software codes, interface data and hardware combination codes to make sure the new firmware repair software works perfectly on the hardware.
Within the latest version of version of WD 2.63, Dolphin engineers have created the following changes and added new firmware repair features below:
1, PCB number display is added;
2, New families are added;
3, To Run ARCO 44 is added when the hard drives are not detected (Not all drives support this), sometimes when users try to write firmware but write failure, users can try to run ARCO 44 and then write again;
Read full details here: http://www.dolphindatalab.com/2015-new-d...l-upgrade/
